1/2" 80 Grit Pin-End SS Belts 4pk

Pin End 1/2″ wide 4-Pack Scroll Sanders

Pin End 1/2″ wide 4-Pack Scroll Sanders.

Recommendations: How to make the best selection for your scroll saw.

• Fits most 5″ scroll saws (Craftsman®, Delta®, DeWalt®, Excalibur®, Ryobi®), but modifications may be required to throat insert or table opening depending upon width of sander used. Be sure to check your table/ throat plate opening before purchasing sanders.
• DeWalt® & Excalibur® Scroll Saws only accept the 1/4″ sanders unless you drill the table hole larger.
• Dremel® 1670, 1671 & 1680: use pin end sanders. Remove nub of plastic at gate to fit into clamp, if necessary.
• Delta®: use side mount, cut table insert to fit sander, or remove table insert.
• Ryobi® SC 160: use pin end sanders.
• Ryobi® SC 162, 162VS & 165: use plain end sanders only.
• Hegner®: use pin end sanders.
• Does not fit RBI®, Reliant®, or Moto-Shop®.
• Plain end sanders fit most conversion kits for mounting blades with plain ends on pin end saws. 

Additional information